Honda 2005 CRF250X - Rear Wheel Installation

REAR WHEEL/SUSPENSION
14-12
INSTALLATION
Install the right and left side collars.
Install the rear brake caliper bracket onto the slide
rail of the swing arm.
Place the rear wheel into the swingarm.
Install the drive chain over the driven sprocket.
Apply a thin coat of grease to the axle.
Install the adjusting block and axle from the left
side.
Install the adjusting block, washer and axle nut.
Adjust the drive chain slack !page 3·21).
Tighten the axle nut to the specified torque .
TORQUE: 127 N'm 11 3. 0 kgf ·m. 94lbf · ftl
Snug the adjusting bolts against the chain adjusters
and
tighten the lock nuts to the specified to rque.
TORQUE: 27 N·m (2.8 kgf ·m. 20 Ibf · tt )
CALIPER BRA.CKE'T