Honda 2005 CRF250X - Engine Stop Button; Tail Light Removal;Installation

LIGHTS/METER/SWITCHES
REMOVALIINSTALLA
TION
Remove the seat (page 2-3).
Remove
the side cover (page 2-3).
'04. '05: Disconnect the taillight 2P connector.
After '05. Disconnect the taillight and leM wire connectors.
Remove the
bolt, washer, screws and wire clamps.
Remove the
bolts, stay and taillight unit.
Install the tait light unit is in the reverse order of
removal.
TORQUE:
Rear fender mounting bolt:
13 N'm (1.3 kgf·m, 9Ibf.ft)
Tail light mounting screw :
3.9 N'm
(0.4 kgf·m, 2.9Ibf.ftl
ENGINE STOP BUnON
19-6
Remove the front visor (page 2-51 .
Disconnect the engine stop button 3P connector.
Check for continuity between the BlackMIhite termi-
nal and Black/Green terminal.
There should be continuity with the engine stop but-
ton depressed. and no continuity with the button
released.
'04, '05
Shown:
BOLT
2P CONNECTOR
CLAMPS
STAY
WASH:E ~ R ~ ;t( t ;;;~
SCREWS
SCREWS
CU
/ TAILLIGHT UNIT