To reduce glare at night, the
instrument panel illumination dims
when you turn the light switch to the
or position.
Y ou can adjust the brightness to t he
desired level with the headlight
switch off, and also with the
headlight switch on. Both settings
will remain at those levels until you
change them.
Each display (upper and lower) will
illuminate with reduced brightness
when you unlock and open the
driver’s door, then go to normal
brightness when you turn the
ignition switch to the ON (II)
position.
If you insert the key but do not turn
the ignition switch to the ON (II)
position, the illumination turns off
after about 10 seconds.
The knob on the instrument panel
adjusts the brightness of the instru-
ment panel. Push on the knob to pop
it out, then turn it to adjust the
brightness.
Pushtheknobbackintoprevent
your setting from accidentally
changing.
The brightness can be shown within
the six brightness levels on the
multi-information display. When you
turn the knob, the lower segment of
the display changes to vertical bars
that show you the current level. Y ou
will hear a tone when you reach the
maximum or minimum brightness.
The brightness level goes out about
5 seconds after you stop adjusting.
Instrument Panel Brightness
Instruments and Controls
144
BRIGHTNESS LEVELS
06/12/06 10:47:52 32SMR600_147
To Next Page
Loading...
