To install a locking clip, do the
following:
Place the child restraint in the seat
with a lap/shoulder belt. Route the
lap/shoulder belt through the
restraint according to t he seat
manufacturer’s instructions.
Insert the latch plate into the
buckle. Pull on the shoulder part
ofthebelttomakesurethereis
no slack in the lap portion.
Tightly grasp the belt near the
latch plate. Pinch both parts of the
belt together so they won’t slip
through the latch plate. Unbuckle
the seat belt.
Install the locking clip as shown.
Position the clip as close as
possible to the latch plate.
If it is necessary to put a front facing
child restraint system in the front,
move the vehicle seat as far t o the
rear as possible, be sure the child
restra int system is firmly secured to
the vehicle, and the child is properly
strapped in the rest raint system (see
page ).
A locking clip is usually included
with the child restraint system. If
you need a clip, contact the seat’s
manufacturer or a store that sells
child restraints.
Always use a seat belt locking clip
when you secure a child restraint
system to your vehicle with a lap/
shoulder belt. This helps prevent the
restraint system fr om shifting
position or overturning.
Insert the latch plate into the
buckle. Push and pull on the child
restraintsystemtoverifythatitis
held firmly in place. If it is not,
repeat these steps until the
restraint is secure.
1.
2.
3.
4.
5.
43
On vehicles without lockable retractor
fitted to the seat where the child is
positioned
Installing a Child Restraint System
Driver and Passenger Safety
Using a Seat Belt Locking Clip
Except for European models
57
LOCKING CLIP
06/12/06 10:36:12 32SMR600_060
To Next Page
Loading...
