The instrument panel has many
indicators to give you important
information about your vehicle. This indicator comes on when you
turn the ignition switch to the ON
(II) position. It reminds you and your
passengers to fasten your seat belts.
A beeper also sounds if you have not
fastened your seat belt.
If you turn the ignition switch to the
ON (II) position before fastening
your seat belt, the beeper sounds
and the indicator flashes. If you do
notfastenyourseatbeltbeforethe
beeper stops, the indicator stops
flashing but remains on.
If a front passenger does not fasten
their seat belt, the indicator will
come on about 6 seconds after the
ignition switch is turned to the ON
(II) position.
If either the driver or a front
passenger does not fasten their seat
belt while driving, the beeper will
sound and the indicator will flash
again at regular int ervals. For more
information, see page .
See page on petrol models and
page on diesel models.
This indicator will also come on
when you restart the engine after
your vehicle has run out of fuel (see
page ).
You will also see the symbol ‘‘ ,’’
or this symbol with a ‘‘CHECK
SYSTEM’’ message on the multi-
information display (see page ).
You will also see the symbol ‘‘ ’’
(for a driver)/‘‘ ’’ (for a front
passenger), or this symbol with a
‘‘FASTEN YOUR SEAT BELT’’ or
‘‘FASTEN YOUR PASSENGER’S
SEAT BELT’’ message on the multi-
information display to remind you
and your passengers to fasten your
seat belts.
The seat belt system also monitors
the seat belt use of all rear seating
positions according to each seat belt
buckle latch function. The multi-
information display will show you the
seat belt use on the rear seat (see
page ).
22
467
468
104
421
98
Malfunction Indicator
Lamp
Seat Belt Reminder
Indicator
On Diesel models only
Instrument Panel Indicators
Instruments and Controls
76
06/12/06 10:38:40 32SMR600_079
To Next Page
Loading...
