Honda 2008 Accord Sedan - Phonebook

CONTINUED
Toerasethecodesstoredinallthree
buttons, press and hold the two
outside buttons until the red
indicator begins to flash, then
release the buttons.
Youshoulderaseallthreecodes
before selling the vehicle.
If you want to retrain a programmed
button for a new device, you do not
have to erase all button memory.
You can replace the existing memory
code using this procedure:
Press and hold the HomeLink
button to be trained until the
HomeLink indicator begins to
flash slowly.
Press and hold the button on
HomeLink for 3 to 4 seconds.
Press the HomeLink button again
for about 1 second. It should
operate the garage door.
Press the training button on the
garage door opener unit until the
indicator next to the button comes
on. The indicator may blink, or
comeonandstayon.Youthen
have approximately 30 seconds to
complete the following steps.
1.
4.
5.
3.
HomeLink Universal Transceiver
Erasing Codes
Retraining a Button
Features
229
LEARN BUTTON
０７／０６／１５ １１：３９：４４ ３１ＴＡ０６００ ０２３４
2008 Accord Sedan