Replacing a Rear License Plate
Bulb
1. Remove the license light assembly
by pushing the left edge of the
lens toward the right and pulling
the assembly out.
2. Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
3. Turn on the parking lights and
check that the new bulb is
working.
4. Put the lens back on the socket
until it locks.
5. Slide the right side of the light
assembly into the hole. Push on
the left side to latch the assembly
into place.
Replacing a High-mount Brake
Light Bulb
1. Open the hatch. Remove the light
assembly cover by pushing in on
the tabs on both sides and pulling
the cover down.
2. Remove the socket from the light
assembly by turning it one-quarter
turn counterclockwise.
LENS
SOCKET
BULB
LENS
TABS
COVER
CONTINUED
Lights
267
Maintenance
To Next Page
Loading...
