40 | | 41
VEHICLE CONTROLSVEHICLE CONTROLS
TABLE OF CONTENTSVISUAL INDEX
VOICE COMMAND
INDEX
SAFETY
INFORMATION
CUSTOMER
INFORMATION
INSTRUMENT PANEL
SPECIFICATIONS
VEHICLE
CONTROLS
MAINTENANCE
AUDIO AND
CONNECTIVITY
HANDLING THE
UNEXPECTED
BLUETOOTH®
HANDSFREELINK®
DRIVING
HONDALINK®
NAVIGATION INDEX
Wiper Operation
The windshield wipers and washers can be used when the vehicle is on. Move the
wiper lever up or down to the desired position.
Pull to
use
washer.
MIST
OFF
INT*: Low speed intermittent
*1
AUTO*: Automatic intermittant
*2
LO: Low speed wipe
HI: High speed wipe
Intermittent (INT) Wipers*
When you move the lever to the INT position, the
wipers operate based on the delay adjustment.
Rotate the adjustment ring to adjust the wiper delay.
Automatic (AUTO) Rain-Sensing Wipers*
When you move the lever to the AUTO position
while driving in rainy weather, the wipers operate
based on the amount of detected rainfall.
Put the lever in the AUTO position only when driving
in rainy weather.
Rotate the adjustment ring to adjust the rainfall
sensor sensitivity.
Return the lever to the OFF position when rain stops.
Rotate the
adjustment ring.
Long delay
Short delay
INT position
Rotate the
adjustment ring.
Low sensitivity:
Heavy rain accumulation
needed for wipers to sweep.
High sensitivity:
Light rain accumulation
needed for wipers to sweep.
AUTO position
* if equipped
*1: models without automatic intermittent wipers; *2: models with automatic intermittent wipers
If you find the timing of beam changes inconvenient for driving, change the beams
manually.
For the system to work properly:
• Do not place an object that reflects light on the dashboard.
• Keep the windshield around the camera clean. When cleaning the windshield, be
careful not to apply windshield cleanser to the camera lens.
• Do not attach an object, sticker or film in the area around the camera.
• Do not touch the camera lens.
If the camera receives a strong impact or requires repair, consult a dealer.
If you see the message “
Some Driver Assist Systems Cannot Operate: Clean
Front Windshield,” park your vehicle in a safe place. Wipe away debris blocking the
windshield, then start driving again. If the message remains even after driving for a
while with the clean windshield, have your vehicle checked by a dealer.
To Next Page
Loading...
