Honda ADV150 2019 User Manual

Brake Fluid
Do not add or replace brake fluid, except in an
emergency. Use only fresh brake fluid from a
sealed container. If you do add fluid, have the
brake system serviced by your dealer as soon as
possible.
NOTICE
Brake fluid can damage plastic and painted
surfaces.
Wipe up spills immediately and wash thoroughly.
Recommended brake fluid:
Honda DOT 3 or DOT 4 Brake Fluid
or
equivalent
Recommended Coolant
Use only genuine HONDA PRE-MIX COOLANT
without diluting with water. Genuine HONDA
PRE-MIX COOLANT is excellent at preventing
corrosion and overheating.
The coolant should be inspected and replaced
properly by following the maintenance
schedule. 2 P. 68
NOTICE
Using coolant not specified for aluminium engines
or tap/mineral water can cause corrosion.
Crankcase Breathers
Service more frequently when riding in rain, at
full throttle, or after the vehicle is washed or
overturned. Service if the deposit level can be
seen in the transparent section of the drain
tube.
If the drain tube overflows, the air filter may
become contaminated with engine oil causing
poor engine performance. 2 P. 99
20191017191217_32K0WC000_eng_BOOK Page 79 Thursday, October 17 2019 19:17:25 JST
Maintenance Fundamentals
Maintenance
76

Honda ADV150 2019 Specifications

General

Displacement	149.3 cc
Bore x Stroke	57.3 mm x 57.9 mm
Compression Ratio	10.6:1
Fuel System	PGM-FI (Programmed Fuel Injection)
Ignition System	Full Transistorized Ignition
Starting System	Electric
Front Suspension	Telescopic Fork
Front Brake	Hydraulic Disc
Rear Brake	Mechanical Drum
Front Tire	110/80-14
Rear Tire	130/70-13
Length	1, 950 mm
Width	763 mm
Height	1, 153 mm
Seat Height	795 mm
Wheelbase	1, 324 mm
Ground Clearance	165 mm
Curb Weight	133 kg
Engine Type	Liquid-cooled, 4-stroke, SOHC
Transmission	Automatic, V-Matic
Rear Suspension	Twin Shock
Fuel Tank Capacity	8.0 L