Honda CRF450RL 2021 - Fork Oil Service

Maintenance
2-66
Loosen the fork bottom bridge pinch bolts [1] and pull the
fork leg [2] down and out.
FORK TUBE OIL DRAINING
Remove the front fork 2-64.
Clean the following before disassemble the fork.
– Fork assembly
– Bottom of the slider around the center bolt
– Sliding surface of the slide pipe
• Be careful not to scratch the slide pipe.
• Be careful not to damage the dust seal.
Measure and record the length between the axle holder
and outer tube before disassembling the fork.
[1]
[2]
Hold the outer tube [1] and remove the fork damper [2]
using the special tool from the outer tube.
Slide the outer tube down onto the axle holder.
Drain the fork oil from the inside of the fork tube and fork
damper oil holes by pumping the fork several times.
Remove the O-ring [1] from the fork damper.
TOOL:
Lock nut wrench, 50 mm [3] 07WMA-KZ30100
[3]
[2]
[1]
[1]