Honda CRF450X 2010 - After 07

FRONT WHEEl/SUSPENSION/STEERING
Position the brake master c ylinder on the handlebar.
Install
the master cylinder holder with its "UP" mark
facing up and align the end of the holder with the
paint mark on the handlebar.
Tighten the upper master cylinder holder bolt first ,
then tig ht en the lower bolt .
TORQUE: 9.9 N'm 11 .0 kgf ·m , 7.3 IbHt )
Install the clutch lever bracket and holder wi th the
punch mark on the holder facing up.
Align the end of the holder w ith the paint mark on
the handlebar.
Tighten the upper bolt fi rst, then the lower bolt
securely.
Installihe engine stop button on the handlebar.
Align the en d of the holder with the paint mark on
the handlebar .
Install the engine stop button screw wi th the washer
and engine stop button wire terminal.
Tighten the engine stop button sc r ew to the speci-
fied to rque.
TORQUE: 1.5 N·m (0.2 kgf ·m, 1. 1Ibf.ft)
Route the wire Clamp the engine stop button / clutch switch wi re
properly {'OS - '07: with wi re bands.
page 1-25. After
'07: page 1 -32! .
PAINT MARK
ENGINE STOP BUleTON MARK
s~ ~ ~
WIRE BANOS
14-37