Honda CRF450X 2010 - Shock Link Needle Bearing

REAR WHEEL/SUSPENSION
SHOCK LINK NEEDLE BEARING
Remove the needle bearing from the shock link.
Pack
new needle bearings wit h grease.
Press rhe needle Press new needle bearings into the pivot wi th the
bearmg mto the special tools an d a h yd raulic press so that the nee-
shock link with the die bearing su rf ace is 4.4 - 4.7 mm (0.17 - 0. 19 in)
marked side facing below the end of the shock arm surface.
OU< .
TOOLS:
Driver
Att a chment , 24 x 26 mm
Pilot, 20 mm
INSTALLATION
07749-0010000
01746·0010700
07746-0040500
Apply mUlti-purpose grease NLGI No.2 (m olybde-
num disu lf ide additive) to the shock a rm , dust seal
lips,
side co ll ar seating surface and needle bearing
rolling area .
• Make su re the needle bearing r ollers are in posi-
tion before installing.
Number of needle roller s:
Shock link side: 32
Swingarm side: 32
Shock absorber side: 27
Install the dust sea ls and washe rs (shock link side ),
Install the dust seals to the shock arm ( swingarm
side).
NE EDLE BEARING
,
,
Install the p ivo t collar, side collars and dust seals
(shock absorber
side), • ~
15-34
Install the pivot collars an d side collars to the shock
arm (swingarm side, shock
link si d e).
SIDE COL LA RS
D
SHOCK LI NK
4. 4- 4 .7 mm
~ (O.17-0.19inl
r-
•
<:! ..
....
NEEDLE
_ !iijjjjj.. B EAR INGS
_..¥iii2t SID E COLLARS
PIVOT CUl.
LA'"
•