Honda CRF50F 2004-2015 - Number Plate Service; Front Fender Service; Exhaust System Service

FRAME/BODY PANELS/EXHAUST SYSTEM
NUMBER PLATE
Remove the breather hose fr om the number plate.
Remove the fender mounting bolt.
Remove the number plate from the steering stem
nut and front fender.
I nstallation is in the reverse order of removal.
FRONT FENDER
Remove the three bolts and the front fender.
Instailation is in the reverse order of remova l.
EXHAUST SYSTEM
REMOVAL
For spark arrester
mamtenance,
refer
to page 3·19
Remove the seat assembly (page 2-3 ).
Remove the exhaust pipe joint nulS.
Remove the mounting bolt and the muffler.
Remove the exhaust pipe joint gasket.
INSTALLATION
Install a new joint gasket inlO the exhaust port.
Set the exhaust pipe onto the engine by aligning the
exhaust pipe flange with the cylinder head studs,
then install the joint nuts and the mounting bolt.
Tighten the joint nuts.
Tighten the mounting bolt.
TORQUE: 26 N'm !2.7 kgf.m, 20 IbHt)
Install the seat assembly ( page 2·3)
NUMBER
2-5