Honda CRF50F 2005 - Gearshift Linkage; Removal; Remove Pinch Bolt and Gearshift Pedal

CLUTCH/GEARSHIFT LINKAGE
Install the clutch outer and tighten the screws to the
specified torque.
TOR
QU E: 4.4 N'm (0. 45 kgf -m.3.3 I bf.ttl
Install the clutch lifter cam plate.
Install the oi llh rough spring and oillhrough .
Install the spring, ball retainer and clutch lifter lever.
Install the right crankcase cover (page 9-19).
GEARSHIFT LINKAGE
REMOVAL
Remove the clutch and primary driven gear (page 9-
6).
Clean the gearshift Remove the pinch bolt and gearshift pedal.
spmdle end /0 pre.-
vent din from amm-
mg rhe crankcase
9-16
G.,\RS HF TPEDAL