38
OPERATION
PRE-RIDE INSPECTION
For your safety, it is ver y impor tant to take a
few moments before each ride to walk
around your motorcycle and check its
condition. If you detect any problem, be
sure you take care of it, or have it corrected
by your dealer.
1. Engine oil level – add engine oil if
required (page 58). Check for leaks.
2. Fuel level – fill fuel tank when necessary
(page 27). Check for leaks.
3. Front and rear brakes – check operation
and if necessary, adjust freeplay (pages
21 – 24).
4. Tyres – check condition and pressure
(pages 32 – 35).
5. Spokes – check and tighten if necessary
(page 74).
6. Drive chain – check condition and slack
(page 69). Adjust and lubricate if
necessary.
7. Chain slider – check slider wear (page
70).
8. Throttle – check for smooth opening and
full closing in all steering positions.
Adjust freeplay if necessary (pages 65 –
67).
Improperly maintaining this motorcycle
or failing to correct a problem before
riding can cause a crash in which you
can be seriously hurt or killed.
Always perform a pre-ride inspection
before every ride and correct any
problems.
37GELA00.book 38 ページ ２０１６年３月３日 木曜日 午後２時１９分
To Next Page
Loading...
