Tools
Crimping
Crimping tool
3. Condition of Stripped Wire
4. Use of Manual Crimping Tool
Open the handle, then insert a contact into the
crimper according to the detailed diagram of the
crimper.
Close the handle so far as the terminal and barrel
are not deformed. Insert the cable to the
conductor stopper, then close the handle until the
ratchet is released.
When reopening the handle, the crimped contact
can easily be removed.
If the handle is required to be opened during
crimping, press the open knob.
Regularly lubricate the driving part in order to
reduce the abrasion on that part.
Remove the excess from wire stripping and scrap
metal from the cable stopper. This scrap material
may cause operation problems.
1.
2.
3.
4.
Maintenance
1.
Note: Do not lubricate the crimping part.
2.
Properly stripped wire
Handle
Crimper
Note 1 Note 2
Open Knob
Ratchet
Conductor stopper
Cable
Contact
Detailed diagram of crimper
Note1: Do not use wire whose strands are cut or irregular.
Note2: Do not use wire which is not neatly stripped, strip
the wire correctly before using.
To Next Page
Loading...
Need help?
General