© 2000 American Honda Motor Co., Inc - All Rights Reserved. 1 of 3
AII 22028 (0008)
INSTALLATION
INSTRUCTIONS
Accessory Application Publications No.
Issue Date
AUG 2000
08A03-S0X-1001-91
ODYSSEY (EX)
CASSETTE PLAYER
P/N 08A03-5B1-050
PARTS LIST
Owner’s manual
Wire tie (not used)
Harness clip
INSTALLATION
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the preset
buttons.
2. Disconnect the negative cable from the battery.
AII 22028
5 Washer-screws
Y0581-D
CONNECTOR
CLIP
COVER
SMALL
FLAT-TIP
SCREWDRIVER
CONSOLE PANEL
TOOLS REQUIRED
Phillips screwdriver
Small flat-tip screwdriver
3. Remove the console cover:
• Move the gear selector lever to the 1 position.
• Using a small flat-tip screwdriver around a shop
towel, gently pry out and remove the cover.
• Reach inside the cover hole, gently pull along the
bottom to release the lower clips, and work
toward the top to release all 10 clips.
• Pull out on the console panel, unplug the
connectors, and remove the panel.
TAB
Cassette player