122
MAN0530 Issue 15 - 07/17 Searchline Excel
2104M0506
At this point, position the units on their mountings so that their optical windows face
each other.
(11) Tighten the mounting support’s nut (M12) and 2 screws (M6x20).
(12) Measure and record the distance (in metres) between the Transmitter and the Receiver
units. This distance is required later in the alignment procedures.
D.2.2.3 Electrical Installation
Refer to Section 3.6.2 of this handbook.
D.2.3 Alignment and Commisioning
Refer to Section 3.7 of this handbook.
D.2.4 Sunshade Installation
Sunshade General View
APPENDIX D - MARINE BRACKET
To Next Page
Loading...
