Chapter 3 — Develop and Install RFID Applications
38 IF1 Fixed RFID Reader User Manual
About RFID Applications
RFID applications that you develop communicate through one of two
RFID services:
• BRI (Basic Reader Interface): Intermec proprietary protocol for
controlling the reader. For more information, see the Basic Reader
Interface Programmer Reference Manual.
• LLRP (Low-Level Reader Protocol): EPCglobal standard for network
interfaces between the RFID reader and its controlling software. The
IF1 supports version 1.0.1 of the EPCglobal LLRP version 1.1. For
more information on LLRP, see http://www.epcglobalinc.org/
standards/llrp.
About the RFID Resource Kit
To create an application, use the RFID Resource Kit. The Intermec by
Honeywell Developer Library RFID Resource Kit includes Java and C#
tools you can use to develop applications that enable control of the
reader and data management.
The resource kit is available as part of the Intermec by Honeywell
Developer Library (IDL). To learn more about the RFID Resource Kit, go
to www.intermec.com and select Products > Applications and
Software > Developer Library > Developer Resource Kits.
About .NET Support
The reader supports applications based on .NET Framework 1.0, 1.1,
and 2.0. The reader uses Mono open source software to provide support
for .NET applications deployed on the Linux operating system of the
reader.
About Java Support
The reader comes with a JDBC driver you can use to create applications
that writes data directly from the reader to a remote database.
To Next Page
Loading...
Need help?
General
