COMPONENT MAINTENANCE MANUAL
1152682
Page 120
Oct 27/06
© Honeywell International Inc. Do not copy without express permission of Honeywell.
23-24-02
33 A/C Address Bit 6 Input Allows programming of 24-bit Aircraft
Address by external switch panel. Open
circuit interpreted as zero.
Optional (if AIM
and the 24-bit DIP
switch module are
both installed)
34 A/C Address Bit 5 Input Allows programming of 24-bit Aircraft
Address by external switch panel. Open
circuit interpreted as zero.
Optional (if NAIM
and the 24-bit DIP
switch module are
both installed)
35 A/C Address Bit 9 Input Allows programming of 24-bit Aircraft
Address by external switch panel. Open
circuit interpreted as zero.
Optional (if NAIM
and the 24-bit DIP
switch module are
both installed)
36 A/C Address Bit 15 Input Allows programming of 24-bit Aircraft
Address by external switch panel. Open
circuit interpreted as zero.
Optional (if NAIM
and the 24-bit DIP
switch module are
both installed)
37 A/C Address Bit 10 Input Allows programming of 24-bit Aircraft
Address by external switch panel. Open
circuit interpreted as zero.
Optional (if NAIM
and the 24-bit DIP
switch module are
both installed)
NOTE:
Logical “1” will be shown by a short circuit.
Logical “0” will be shown by an open circuit.
TABLE 105. REMOTE PANEL CONNECTOR J1 PIN-OUTS
Pin Pin Label (I/O) Description Requirements
A AURAL CHIME Output +28 V dc input in necessary at pin N.
Will then supply 28 V dc output during
transmit. At other times, an open
circuit.
Optional
B LINK2 Input/
Output
Connected to pin V. Optional
C ELT ON Input From ELTON1 on transmitter unit.
Contact closure to ground during
transmit. Connected internally to
pin H.
Optional
D RESET1 Output To transmitter unit, to send the
position of the 3-position functional
switch.
Required
E EXTERNAL ON Output To transmitter unit, to send the
position of the 3-position functional
switch.
Required
TABLE 104. NAIM P/N 1153396-1 CONNECTOR J1 PIN-OUTS (Cont’d)
Pin Pin Label (I/O) Description Requirements
To Next Page
Loading...
