3 - 6
5. Press the Power key to wake the terminal and check the touch panel with the stylus.
6. Verify that the screen accepts input from the stylus as usual. If not, re-apply the screen protector.
7. Press the orange Power button to put the terminal back in Suspend Mode.
8. Clean the surface of the screen protector with a clean, non-abrasive, lint-free cloth.
9. Press the Power key to wake the terminal again.
10. For maximum performance, recalibrate the screen. Tap Start > Settings > Control Panel > double
tap Stylus > Calibration tab.
To Next Page
Loading...
