4 - 24
Transmit “No Read / Decode” Message
Use this parameter to decide whether a message is sent to the host when a bar code symbol does not decode.
When enabled, and a symbol does not decode within either:
• A scan button press activates the laser and decode processing, the processing continues until a scan button release, or
• The laser decode processing continues until the Laser On Timeout is reached.
• A “NR” (No Read) is transmitted to the host. Any prefix or suffixes which have been enabled are appended around this
message.
When disabled, and a symbol does not decode, no message is sent to the host.
Select an option by scanning either of the bar codes shown below.
Enable No Read
* Disable No Read
To Next Page
Loading...
