Honeywell ACUIX - Setting Exposure; Table 7-1 Auto Exposure Control Mode Settings

ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 41
04/11
Setting Exposure
Auto Exposure (AE)
You can toggle auto exposure on or off by using special preset 92 when the
dome is configured for MAXPRO-mode/VCL/VCL UTC/Pelco P/Pelco D protocol.
To enable/disable auto exposure:
1. Exit the OSD menus until you have manual control of the dome.
2. Enter preset 92 on your controller to toggle auto exposure on (default) or
off.
Setting the Auto Exposure (AE) Mode
You can set the auto exposure to Auto AE mode or to Manual AE mode. You can
also slow the AE response speed to minimize exposure changes caused by
momentary bright spots in the image.
To set the Auto AE mode:
1. Ensure that auto exposure is enabled (preset 92).
2. Enter preset 90 on your controller to return to bring up the OSD main menu.
3. Select 5 Camera Options
 2 Exposure Control  1 Auto AE Mode.
4. Select the desired setting using Table 7-1 as a reference. The features
associated with each exposure mode are displayed below the menu
options.
Table 7-1 Auto Exposure Control Mode Settings
Setting NightShot
Control
Auto
NightShot
Sensitivity
Digital Slow
Shutter
Auto AE Mode MAN NA OFF
Auto AER1 Mode AUTO HIGH OFF
Auto AER2 Mode AUTO MID OFF
Auto AE+ Mode MAN NA AUTO
Auto AER+1 Mode (default) AUTO HIGH AUTO
Auto AER+2 Mode AUTO MID AUTO
Auto AER+3 Mode AUTO LOW AUTO