50
Operation and Programming with Honeywell Diamond Protocol
The following options are displayed on the monitor:
9. Press + or - until the character for the desired action displays on the LCD screen and
then press Character Select. To save Sector coordinates, press + or - until S
displays on the LCD screen and press Character Select. Refer to Figure 3-2 for
programming coordinates.
Figure 3-2 Sector ID Coordinates
a. Using the joystick, move the ACUIX so the lower left corner of the sector is
centered on the monitor, and then press Enter.
b. Using the joystick, move the ACUIX so the upper right corner of the sector is
centered on the monitor, and then press Enter.
Note If the upper right tilt position is below the lower left tilt position, the message
Illegal Tilt Direction displays. Re-adjust the tilt position until the
message disappears or press Clear/Manual to cancel the operation and
return to manual operation.
10. Repeat step 6 to step 9 to continue programming Sectors or press Clear/Manual to
return to manual operation.
11. Press Dome Menu or Menu ESC to exit the Dome Menu on the LCD display.
Table 3-9 Sector ID Commands
Command Function
E to Edit Sector Press + or - key until E displays on the LCD screen and
press Character Select. Repeat step 8.
D to Delete Sector Press + or - key until D displays on the LCD screen and
press Character Select. The Sector number entered in
step 6 is deleted.
S to Save Sector
Coordinates
Press + or - until S displays on the LCD screen and
press Character Select. Follow the instructions in
step 9 for saving the Sector coordinates.
N to Save Name only Press + or - until N displays on the LCD screen and
press Character Select. This option is used for
renaming Sector IDs. Only the title entered in step 8 is
saved for the Sector number entered. The current
Sector coordinates are not changed.
Right pan
Top tilt
Bottom tilt
Left pan
To Next Page
Loading...
