System Communication and Operation
6-7
Assigning Attributes: Master code + [8] + 2-digit user no. + [#] [attribute no.] + value
Attributes: Values
1 = Authority Level 0-4 (see Authority Level table above)
2 = Access Group 0-8 (0 = not assigned to a group)
3 = Active Partition(s) 1, 2, 3
for this user; Enter partitions consecutively if more than one and press
[#] to end the entries.
4 = RF Zone No. Assigns user number to button type zone for arm/disarm
(keyfob must be enrolled in system first; see Wireless Key
Templates section)
5 = Open/Close Paging 1 for yes, 0 for no
6 = Open/Close Report to 1 for yes (default = yes for all users), 0 for no
Monitoring Station
SUMMARY OF ARMING MODES
Features for Each Arming Mode
Arming Mode
Exit Delay Entry Delay Perimeter Armed Interior Armed
AWAY Yes Yes Yes Yes
STAY Yes Yes Yes No
NIGHT-STAY Yes Yes Yes
only those zones
listed in Night-Stay
zone list
INSTANT Yes No Yes No
MAXIMUM Yes No Yes Yes
Keypad Functions
The following is a brief list of system commands. For detailed information concerning
system functions, refer to the User's Manual.
Keypad Commands
Function Description
Silence alarms Pressing any key will silence the keypad sounder for 10 seconds.
Disarming the system will silence both keypad and external sounders.
Quick Arm If enabled (field ∗21), you can press [#] in place of the system's security
code, plus the desired arming key (Away, Stay, Instant, Maximum)
Single-Button arming If programmed (*57 Function Key menu mode), lettered keys A-D can be
used for arming, using options 3-AWAY, 4-STAY, 5-NIGHT-STAY, or 6-
Step-Arming
If used, no security code is required to arm the system.
Alarm Memory When the system is disarmed, any zones that were in an alarm condition
during the armed period will be displayed. To clear this display, simply
repeat the disarm sequence (enter the security code and press the OFF
key) again.
To Next Page
Loading...
