L4006,7,8; L6006,7,8 AQUASTAT
®
CONTROLLERS
60-2104—10 18
MATERIAL SAFETY DATA SHEET
Section 1. Product And Company
Identification
Product Name: Heat Conductive Compound
MSDS ID: DS9021
Synonyms: MS1699
Product Use: Heat conductive material used to enhance
contact and heat transfer in temperature sensor applications.
Manufacturer: Honeywell Inc., 1985 Douglas Drive North,
Minneapolis, MN 55422.
Date Released: October 8, 1999
NFPA Ratings:
Health 0; Flammability 1; Reactivity 0; Personal Protection B
Section 2. Composition,
Information on Ingredients
Additional Information: Part No. 120650 (0.5 oz tube); Part No. 107408 (4 oz can); Part No. 197007 (5 gallon container). May also
contain minute amounts of lithium and molybdenum lubricant compounds.
Section 3. Hazard Identification
Acute Health Effects:
Skin: Excessive contact may cause skin irritation and
dermatitis.
Eye: Direct contact with eye will cause irritation.
Inhalation: No adverse effects are expected.
Ingestion: Ingestion of product may cause nausea, vomiting
and diarrhea.
Chronic Health Effects:
Existing skin rash or dermatitis may be aggravated by
repeated contact.
OSHA Hazard Classifications: None.
Carcinogenicity: Not considered to be a carcinogen by
either OSHA, NTP, IARC, or ACGIH.
Section 4. First Aid Measures
Eye Contact: Flush eyes with water for 15 minutes. Remove
any contact lenses and continue to flush. Obtain medical
attention if irritation develops and persists.
Skin Contact: Remove excess with cloth or paper. Wash
thoroughly with mild soap and water. Obtain medical
attention if irritation develops and persists.
Ingestion: Contact physician or local poison control center
immediately.
Inhalation: Remove patient to fresh air and obtain medical
attention if symptoms develop.
Section 5. Fire Fighting Measures
Material Flash Point: > 383° F (195° C). Will burn if exposed
to flame.
Extinguishing Media: Carbon dioxide, dry chemical or foam.
Special Fire Fighting Procedures: None.
Explosion Hazards: None. Aluminum powder can react with
water to release flammable hydrogen gas. In this form of the
product, this reaction is not expected.
Ingredient CAS Number Percent PEL TVL
#2 Lithium Complex Grease (70%):
Mineral Oil 64742-65-0 35-50
5 mg/m
3
5 mg/m
3
Mineral Oil 64742-62-7 20-25
5 mg/m
3
5 mg/m
3
Lithium Hydrostearate/Sebacate
Complex
68815-49-6 4-9 — —
Zinc Alkyldithiophosphate 68649-42-3 0-2 — —
Aluminum Paste (30%):
Aluminum, as Al 7429-90-5 20-25
15 mg/m
3
10 mg/m
3
Aliphatic Petroleum Distillates 8052-41-3 10-15
2900 mg/m
3
525 mg/m
3
Stearic Acid 57-11-4 1-2 — —
Aromatic Petroleum Distillates 64742-95-6 1-2
5 mg/m
3
5 mg/m
3
To Next Page
Loading...
