Honeywell BC-200 - Page 34

Panel Operation
BC-200 Manual – P/N DOC-01-013 34
7.3.3.7.1 SERVICE MENU – LIST – LIST – ANALOG – DETECTORS
This screen will provide a list of all Analog addressable detectors (1-99) on the loop selected showing the name of
each detector alongside.
An alarm, fault or isolate flag will also appear on the right hand side of the line for easy status reference.
From this screen you can do a live read status of the point or change the configuration of the point.
Detectors that are not installed are listed as “NOT INSTALLED”, performing a change on a detector will
automatically install it.
USE BUTTONS TO SELECT DEVICE:
L1D1 FIRE CONTROL ROOM
L1D2 APARTMENT 1 BATHROOM F
L1D3 APARTMENT 1 LIVING AREA A
L1D4 APARTMENT 1 BEDROOM
L1D5 APARTMENT 2 BATHROOM
L1D6 APARTMENT 2 LIVING AREA
L1D7 APARTMENT 2 BEDROOM
L1D7 SECURITY OFFICE
L1D8 CARPARK DETECTOR #1 I
L1D9 CARPARK DETECTOR #2
L1D10 CARPARK DETECTOR #3
L1D11 LIFT MOTOR ROOM
L1D12 NOT INSTALLED
L1D13 NOT INSTALLED
L1D14 NOT INSTALLED
L1D15 NOT INSTALLED
L1D16 NOT INSTALLED
ANALOG LIST – DETECTORS
A = 1
F = 1
I = 1
N = 0
01 OC
T 1999 14:44:37
DOWN
UP
01 OCT 1999 14:44:37
DOWN
UP
20 JULY 2002 14:44:37
UP
STATUS CHANGE BACK
DAY MODE
CHANGE
BACK
Actions:
 Use the UP and DOWN buttons to select
detector.
 Use the STATUS button to perform a live point
read on the detector.
 Use the CHANGE button to display soft buttons
ADD and REMOVE . Use ADD to edit the
detectors setting and/or change its name.
 Press BACK to return to the previous screen.
Note: You can also use the arrow keys, the Page Up and Page Dn keys on an external keyboard for scrolling
functions.