Panel Operation
BC-200 Manual – P/N DOC-01-013 41
7.3.3.8 SERVICE MENU – LIST – LIST – RING
This screen will display a list of all installed rings.
RING 1 (CONVENTIONAL)
RING 3 (ANALOG)
RING 4 (NETWORK)
RING LIST
20 JULY 2002 14:44:37
DOWNUP BACK
ACTIVE RINGS DETECTED:
USE UP/DOWN BUTTONS TO SELECT A RING:
A = 0
F = 0
I = 0
N = 0
DAY MODE
SELECT
Use the UP and DOWN buttons to scroll through the
list of active rings.
Use the SELECT button to select the currently
highlighted ring.
7.3.3.8.1 SERVICE MENU – LIST – LIST – RING – MODULE LIST
Once you have selected the ring, the following screen will appear.
MODULES FOUND ON RING 1
001 002 003 004 005 006 007 101 102 103
MODULE LIST
20 JULY 2002 14:44:37
NEXTPREV SELECT
USE BUTTONS TO SELECT A MODULE:
A = 0
F = 0
I = 0
N = 0
DAY MODE
Use the PREV and NEXT buttons to scroll through
the list of active modules.
Use the SELECT button to select the currently
highlighted module.
If the Analog addressable ring (#3) is selected, you will
be taken directly to the List – Analog screen (see page
33)
Note: If the module number is displayed with an asterisk (*) beside it, it means the module has been manually
programmed in but never “seen” by the panel.
To Next Page
Loading...
