EAGLEHAWK NX CONTROLLER BASIC OPERATION PROCEDURES
25 EN2Z-1053GE51 R0119
5. Turn the rotate&push button to navigate to and highlight the desired
datapoint.
6. Push the rotate&push button. The datapoint details display.
7. Turn the rotate&push button and select the Manual line with the checkbox
symbol.
8. Push the rotate&push button. The Manual checkbox is checked.
9. Turn the rotate&push button to navigate to the value and set the value as
described in the “Adjusting and Saving Values and Options“ section, p. 19.
To Next Page
Loading...
