Honeywell CIU 888 - Page 112

Getting Started
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 3 - 82
$*6
7. The G1 node is created and displayed under Tank T1.
You can view or edit these properties.
Properties Description
DensityCalculationType This parameter indicates the HIMS density calculation
type.
P1SensorPosition The position of the center of the Liquid Pressure sensor
membrane. This is expressed in m.
P3SensorPosition The position of the center of the Vapor Pressure sensor
membrane. This is expressed in m.
HybridMinLevel This value specifies the lowest product level at which
the Observed Density would be calculated.
CIU Parameter This indicates the CIU parameter name to which the
scanned TRL/2 field device parameter has to be
mapped. CIU Service tool displays all the CIU Parame-
ters which can be scanned from TRL/2 field devices in a
drop down menu.
Device Type This is the TRL/2 field device type. For example,
Emersion Rex, Honeywell TRL/2 Gauge. CIU Service
tool displays all the supported device types in a drop
down menu.
Device Slave ID Each TRL/2 device is addressed with a unique slave ID.
That is, when a request is received by a Modbus
device, it checks the TRL/2 slave ID in the request and
if it matches with its configured slave ID, it responds
back, else it skips the request. This indicates the TRL/2
RTU address of the field device.