Honeywell CIU 888 - Page 162

Commissioning of a Standalone System Setup
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 4 - 17
$*6
To verify the working of the system setup, the CIU 888 must be
connected to:
 PC/laptop running the CIU 888 Service Tool via Service port located
at the front using a Cat. 5 Ethernet cable
 PC/laptop running the Modbus Host (e.g. Entis Pro) via one of the
configured serial host ports using RS-232/RS-485 cable (see
FIGURE 4-14)
FIGURE 4-14 CIU 888: Serial host ports
 PC/laptop running the Modbus TCP/IP Host and / or OPC UA TCP
Host via one of the configured ethernet host ports using network
cable (see FIGURE 4-15)
FIGURE 4-15 CIU 888: FTE A, FTE B and LAN ports