Honeywell CIU 888 - CIU 888 Service Tool License

Installing CIU 888 Service Tool
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 2 - 14
$*6
2.4 CIU 888 Service Tool License
CIU 888 Service Tool license is generated based on the MAC address
of the PC/Laptop where it will be used. To obtain a Service Tool license,
you must send the MAC address and the general information of the PC/
Laptop (where the CIU 888 Service Tool is installed) to Honeywell
GTAC.
NOTE 1: This procedure would take a minimum of 2-3 days. Please plan for the same,
so that you have the license ready before you begin the commissioning
process.
NOTE 2: CIU 888 Service Tool R150 license has a new encryption algorithm. Hence CIU
888 Service Tool needs a new License to be requested. Existing machines
which already have Service Tool R101.1 also need to request for the new
license using the above mentioned procedure.
Once you have received the license file, complete these steps to install
the license file.
1. Click (Start) > All Programs > Honeywell > Configuration >
CIU 888 Service Tool. The Browse For Folder window appears.
2. Browse to the license file received from the factory. Click OK.
3. CIU 888 Service Tool validates the license and starts the
application.
NOTE: Once the license is validated, the same license file will be read automatically
for subsequent usage.