Getting Started
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 3 - 47
16.On the Tank1 node, right-click and choose Add Tank Capacity
Table.
The following window appears.
RD1 Reference distance from top surface measuring pipe 1
to liquid level
RD2 Reference distance from top surface measuring pipe 2
to liquid level
RD3 Reference distance from top surface measuring pipe 3
to liquid level
Hpavg Average height top measuring pipe to lowest edge pon-
toon bottom
Vconst Liquid volume under the pontoon membrane and bot-
tom, calculated during tank calibration.
Total cross section area
of FR
Total cross section area of floating roof
Calibration Liquid Density Calibration Liquid Density
This is the density (observed) of the product under a
roof, used during tank calibration, in kg/m3
Properties Description
To Next Page
Loading...
