Honeywell CIU 888 - Page 97

Getting Started
Part No.: 4417584_Rev12 Configuration Manual
CIU 888 3 - 67
$*6
6. Click the Level tab, the Properties detail appears.
You can view or edit these properties:
7. Click the Water tab, the Properties detail appears.
You can view or edit these properties:
Properties Description
Level enabled Check to enable level scan.
Negative level enabled Check to enable the option. This selection is only possi-
ble for gauge types 854, 872, 873, 894 and 954.
0.1 mm level resolution Check to enable the option. This selection is only possi-
ble if the level engineering unit is set to ‘m’ or ‘mm’ and
if the gauge type is not 811, 813, 866 or 872.
No alarm when gauge in
test
Check to disable gauge alarms during operational com-
mands.
Level address Enter level transmission address.
Level TOI Select B, C, E, or M*.
Level TOR Select B, ZLQ or L (the combination of level TOR
‘ZLQ’ and level type ‘Ullage’ is not possible. With level
type ‘Ullage’, use level TOR ‘L’)*.
* Refer to TABLE 3-1 for additional information.
Properties Description
Water probe enabled Check to enable water level scan from external probe.