CHAPTER
1
ABOUT THIS GUIDE
This publication provides the information on hardware planning,
installation, operation and maintenance for Honeywell CN100
Controller.
For software and firmware considerations, see Experion Control
Builder User’s Guide.
Revision history
Revision Date Description
A August 2020 Initial release of document
Introduction to Experion Technology
Item Description
CN100
Module
CN100 controllers running the eCLR (IEC 61131-3) execution
environment with CN100 software options configured with Control
Builder.
Network
Adapter
Module (NAM)
Network Adaptor Modules (CC-INAM01) provides for Uplink
Ethernet connections and supports copper or Fiber connectivity.
Special terms
The following table describes some commonly used industry-wide
and Honeywell-specific terminology:
Terminology Description
NAM Network Adapter Module
5
To Next Page
Loading...
