Chapter 2 — Printer Basics
10 PrintPAD Series CN70/70e & CN51 User Guide
Load the Media
1 Press a new roll of paper in the paper cavity. The end of the roll should exit
from the bottom of the paper cavity and face the printer’s roller. When
properly installed, the roll of paper latches into place.
2 Raise the printhead release lever until it is fully open. The lever clicks
midway at the partially open position; however, do not stop here and
continue to raise the lever until it is fully open.
3 Wake up the printer by momentarily pressing the red self
-test button.
4 Feed the end of the paper and center it under the roller until the paper exits
from the top of the printhead. The printer has an auto
-advance feature that
will aid moving the paper through the printer. Verify the paper exits straight.
Roller
End of paper roll
Paper latch
Printhead release lever
Self-test button
To Next Page
Loading...
