8 - 2
Note: All server-assigned IP addresses use Dynamic Host Configuration Protocol (DHCP).
Connections Manager
Microsoft’s Connections Manager sets up multiple network connections to the Internet Service Providers (ISPs) via the external
modem.
Note: Do not enter connection parameters in the connections manager if:
• You are using one of the on-board wireless radios to connect to a network. The Dolphin 6000 terminal uses the settings from
each radio’s configuration utility to connect.
• You are using Wireless Zero Config. By default, WZC is disabled on Dolphin 6000 terminals.
Icon Description
Beam Enables Bluetooth file transfer.
Connections Opens Microsoft’s connections manager. Refer to Connections Manager on page 8-2.
Dolphin Wireless
Manager
Manages the wireless radios installed on the terminal. Refer to Dolphin Wireless
Manager on page 8-4.
USB to PC Enables advanced wired USB to PC communication via sync software. Refer to
Connecting and Synchronizing the Terminal and Workstation on page 8-4.
Wireless LAN Enables configuration of Wireless Zero Config (WZC). This icon appears only if the
802.11b/g driver is loaded on the terminal and the WLAN Security Supplicant is not
loaded.
By default, the Wireless Zero Config is disabled and the supplicant is loaded. This icon
appears only if you removed the supplicant and cold booted the terminal.
Domain Enroll Connects the phone to the company resources.
Connect Config Enables automatic data configuration.
WLAN Mode Enables WLAN configuration.
To Next Page
Loading...
