2 - 4
Belt Mount Applications
This section describes how to install and mount the belt mount configuration.
Install the Terminal in the Belt Mount Sled
• Trim the straps to length and use the provided clips to terminate the strap
end.
2. Align the sled assembly with the arm band and press
on the sled until it latches onto the arm band. Be sure
to align tabs on the back of sled with the notches on
the arm band. The end of the sled with the ring
scanner connector must face toward the hand.
3. If using the ring scanner (Connect the Ring Scanner
(Optional) page 2-9), slide the ring scanner over the index
finger and adjust the strap (if applicable) for a comfortable fit.
4. To remove the sled assembly, unbuckle and loosen the straps. It is not necessary to remove the strap from the buckle.
1. If the end cap is installed on the sled, slide the lock down to release the
end cap.
To Next Page
Loading...
