1 - 1
1
Getting Started
Out of the Box
Verify that the carton contains the following items:
• Dolphin 75e handheld computer (terminal)
• 1 GB, 2 GB or 4 GB industrial grade microSD™ memory card (optional)
• Rechargeable 3.7V Li-ion battery
• USB charge/communication cable
• Power adapter with regional plug adapters
• Product documentation
If you ordered accessories for your terminal, verify that they are also included with the order. Be sure to keep the original
packaging in case you need to return the Dolphin terminal for service.
Memory Card Specifications
Honeywell recommends the use of Single Level Cell (SLC) industrial grade microSD or microSDHC™ memory cards with
Dolphin terminals for maximum performance and durability. Contact a Honeywell sales representative for additional
information on qualified memory card options.
Initial Setup for Dolphin 75e Terminal
Step 1. Install the Battery
Before installing the main battery, read the Guidelines for Battery Pack Use and Disposal on page 2-13.
The terminal is shipped with the battery packaged separate from the unit. To install the battery, follow the installation steps
illustrated. For information on how to remove the battery, see Replacing the Battery on page 1-12.
Important: All battery and connector doors must be present, undamaged, and properly closed to maintain the
environmental rating of the terminal.
Note: Standard battery and standard battery door shown.
Ensure all components are dry prior to placing the battery in the terminal. Mating wet components may cause
damage not covered by the warranty.
We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell battery may result in damage
not covered by the warranty.
To Next Page
Loading...
