1 - 5
3. Touch NFC.
4. Hold the NFC tag close to the back of the terminal. When an NFC tag is recognized, “configuration received”
appears under the NFC option.
5. Touch next. “Configuration in progress” appears on the screen. When the terminal is done booting, the Start
screen appears.
To use an NFC enabled device:
1. Verify Tap to share and Bluetooth is enable on the sending device.
2. Press the Power button on the terminal.
3. From the Welcome screen, select a language, and then next.
4. Touch NFC.
5. On the sending device, locate and select the prov.xml file. The maximum file size allowable is 128 KB.
6. Touch Share.
7. Hold the terminal back to back with the sending device.
When the entire Prov.xml is received, “configuration received” appears under the NFC option.
8. Touch next. “Configuration in progress” appears on the screen. When the terminal is done booting, the Start
screen appears.
Unlocking the Screen
Swipe up from the bottom of the screen to unlock the terminal and access the Start screen.
For information on customizing the security feature, see Managing Security and Customizing the Screen Lock on page 5-2.
To Next Page
Loading...
