6 - 10 Rev A
8/6/08
Dolphin® Power Tools User’s Guide
RASMan
RASMan establishes a PPP (Point-to-Point Protocol) connection with a RAS server.
To Enable RASMan
1. Tap Start > Power Tools. The Power Tools Main Window (see page 1-2) appears.
2. Click the RASMan icon once . The PPP connection is established according to the settings in
the RASMan Configuration File (see page 6-11).
Note: To start RASMan automatically after each hard reset, enable the RASMan Program section of the
Autorun.exm File (see page 4-1).
To Disable RASMan
Navigate to the Power Tools Main Window (see page 1-2) and tap the RASMan icon again.
OR
Select Exit on the Command Bar Menu (page 6-10).
Command Bar Menu
When RASMan is enabled, the RASMan icon appears in the Command bar at the bottom of the Today
screen . Tap this icon to open the Command bar menu.
Menu Item Selecting this item …
Auto Connect This item is selected by default; it means that the terminal is connected to the RAS server via
PPP.
Connect Re-establishes the PPP connection if it was disconnected.
Disconnect Disconnects the PPP connection.
About Displays version and description information about RASMan.
Exit Disables RASMan; the icon no longer appears in the Command bar.
To Next Page
Loading...
