8 - 2 Rev A
8/6/08
Dolphin® Power Tools User’s Guide
5. Drill-down to the appropriate registry entry. When you click on registry entry in the top half of the
screen, the data appears in the lower half of the screen.
The two columns in the bottom half of the window show the Value Name and the Value Data of the
selected entry.
6. Double-click on the Value Name. The Edit Value window pops up.
In the Value Data field, type the new value.
7. Press the ENT(ER) key or tap OK. The new data appears in the list.
8. After all your edits are complete, Warm Boot (see page 6-13) the terminal to save your changes to
the registry.
Note: If you want your edits to persist through the next cold boot, run RegBackup after saving your changes; see
Backing Up the Registry on page 8-6.
To Next Page
Loading...
