Honeywell Dolphin 9900 - Centering Section

Dolphin® Power Tools User’s Guide Rev A
8/6/08
5 - 11
Centering Section
The Centering section determines the centering window for bar code scanning.
ScanWedge Entry Description Default
Value
Available Values
CenteringEnable= Enable and disables the decode
centering window for the decoder.
0 0=Disabled; centering is
disabled for ScanWedge.
1=Enabled; bar codes are
decoded only if they are
within the centering window
specified by the rest of the
keys in this section.
CenteringTop=
Specifies the top coordinate of the
centering window.
210 Enter the coordinates in pixels.
CenteringBottom=
Specifies the bottom coordinate of
the centering window.
270
CenteringLeft=
Specifies the left coordinate of the
centering window.
346
CenteringRight=
Specifies the right coordinate of
the centering window.
406