Honeywell DT92 User Manual

DT92 WIRELESS DIGITAL ROOM THERMOSTAT
11
Reset Stored Data in Room Thermostat
Follow the sequence of steps below to reset the stored
binding data in the room thermostat.
Put Room Thermostat into Binding Mode
Bind Room Thermostat to Relay Box
With both units in binding mode, pressing the
off/standby button on the room thermostat will bind
them together.
To verify it is now bound, the red light on the relay box
will immediately stop flashing. After about 5 seconds,
the room thermostat will come out of binding mode and
go back to off mode.

Honeywell DT92 Specifications

General

Type	Digital Thermostat
Display	LCD
Control Mode	TPI (Time Proportional Integral)
Switching Voltage	230V AC
Protection Class	IP30
Accuracy	±0.5°C
Backlight	Yes
Power Source	2 x AA Batteries
Communication	Wireless
Wiring	2-wire
Switching Current	8A resistive, 3A inductive
Compatibility	Compatible with most heating systems