30
Installing the Honeywell IP Utility and HD3MDIP/X Web-Client Software
About the Web-Client
The Web-Client is the web-based application that enables users to:
• View live-streaming video.
• View the device network settings and firmware details.
• Configure camera settings
• Configure video analytics settings.
• Configure compression settings.
• Configure alarm and audio settings.
User Profiles: Honeywell IP Utility and Web-Client
Both the Honeywell IP Utility and the Web-Client have two user types: Administrator and
Guest as described in Table 3-1.
Note Only one Administrator and only one Guest can be logged on at a time.
After the IP Utility software is installed, you can change the Administrator or Guest
passwords.
Table 3-1 User Profiles for Honeywell IP Utility and the Web-Client
Interface Administrator Guest
Honeywell IP
Utility
• View the list of available network devices
and connect to the devices.
• Configure the IP network settings.
• Upgrade firmware.
• Change the password to access the IP
Utility application.
• Change the access passwords to the
Web-Client application.
• View the list of devices available on the
network.
• View system settings including device
name, IP address, and MAC address.
Web-Client • View video and network settings.
• Configure compression settings.
• Configure camera setup.
• Configure video analytics.
• Configure audio and alarms.
• Guest users are limited to the Live View
tab where they can view video
To Next Page
Loading...
