Document 800-04194V1 Rev A 15
07/11
3
Installing the Scan Assembly
This chapter contains the following sections:
• Preparing to Install the Scan Assembly, page 15
• Installing the Scan Assembly, page 20
• Installing the Bubble, page 20
Preparing to Install the Scan Assembly
Before you install the scan assembly in the housing, you must first set the dome
address, protocol, baud rate, and parity using the DIP switches located on the
scan assembly main board.
CAUTION
To prevent damage to the scan assembly main board,
follow standard industry precautions for electrostatic discharge
sensitive devices.
CAUTION
Ensure that cabling does not interfere with the rotation
of the scan assembly.
To Next Page
Loading...
