Identify C300 Controller components
I/O modules supported by the C300 Controller
R301.1 Experion C300 Controller User's Guide 13
11/06 Honeywell
Series A I/O Module Model
Conformally Coated
Model Number
DeviceNet Interface (supported by CCL) 1756-DNB
Identify C300 Controller components
Table 2 identifies the C300 Controller components and its associated components. The
C300 Controller supports non-redundant and fully redundant operation. Redundancy is
built in to the controller, so that just adding another controller and a redundancy cable; a
redundant controller pair is achieved. Note that the ‘CC’ designation on the model
number indicates the printed wiring boards are conformally coated for additional
protection from the environment, (CU = uncoated).
Table 2 Series C Hardware components
Series C
Component
Description Model Number
C300 Controller
Module
A distributed process controller and I/O
gateway for the Experion system. Module
contains printed circuit assemblies, status
indicators and a display, inside in a plastic
housing. Module mounts to its Input
Output Termination Assembly (IOTA).
CC-PCNT01
CU-PCNT01
C300 Controller
Input Output
Termination
Assembly (IOTA)
Provides the connection point for the
C300 Controller module and all cable
terminations to the controller, (FTE,
IOLink, Redundancy, Battery and Time
Source cable terminations). Provides 24
Vdc power distribution to the controller
module.
Note: The C300 Controller IOTA supports
only one controller module.
CC-TCNT01
CU-TCNT01
9 Port FTE
Control Firewall
Module
Provides FTE distribution to in-cabinet
network nodes, (other C300 Controllers
and Series C FIMs)
CC-PCF901
CU-PCF901
9 Port Control
Firewall IOTA
Provides connection for eight FTE cables
from in-cabinet controllers and Series C
FIMs. The 9
th
port provides an uplink to
the FTE supervisory network. Provides 24
Vdc power distribution to the control
CC-TCF901
CU-TCF901
To Next Page
Loading...
