Canadian Application
206 MS-9050UD PN 52413:C 01/23/08
H.2 AC Power Connections for Canadian Applications
For Canadian applications, an AC terminal block is supplied standard with the MS-9050UDC. The
AC terminal block is factory installed on the bottom left of the circuit board chassis.
CAUTION! Turn off all power (AC & DC) before making any connections.
Refer to the following illustrations for location and wiring information.
FACP Chassis
AC Terminal Block
AC Hot
AC Neutral
AC Ground
CAUTION! Make certain that all
power (AC & DC) has been turned
off before making any connections.
Connect wires from AC main to
terminal block as shown.
Ground wire to FACP backbox Earth Ground stud
transformer
connections
Figure H.3 AC Terminal Block Connections
To Next Page
Loading...
