Programming
90 MS-9050UD PN 52413:C 01/23/08
3.6.5.1 Trouble Reminder
The Trouble Reminder features causes the control panel piezo to sound a reminder ‘beep’ for
alarms and troubles, after the panel has been silenced. Refer to "System Setup" on page 89, for
a detailed description of this feature. Pressing 1 while viewing System Setup Screen #1 will
cause the display to toggle to Trouble Rem On, which enables this feature. Each press of the 1
key will cause the display to toggle between Trouble Rem On and Trouble Rem Off.
3.6.5.2 Banner
The top line of the display, which appears when the control panel is in normal mode, can be
changed by using the Banner option. Pressing 2 while viewing System Setup Screen #1 will
cause the following to be displayed:
Pressing 1 while viewing the Banner Screen will select the factory default banner setting and
display the following screen:
Pressing the Enter key will store this selection in nonvolatile memory and return the display to
the Banner Screen.
Pressing 2 while viewing the Banner Screen will cause the following screens to be displayed:
See Page
BANNER
1=FACTORY
2=USER DEFINED
Banner Screen
BANNER
1=FACTORY
2=USER DEFINED
Banner Screen
FACTORY BANNER
Factory Banner Screen
USER DEFINED BANNER
PRESS ENTER IF OK
User Defined Banner Screen #1
USER BANNER - LINE 2
PRESS ENTER IF OK
************
User Defined Banner Screen #2
To Next Page
Loading...
