Honeywell FocusPRO 6000 Series - Adjust program schedules; Set weekday wake time; Set weekday leave time; Set weekend time periods

3
Program schedule override (temporary)
To adjust program schedules
1. Press SET CLOCK/DAY/SCHEDULE,
then SET SCHEDULE.
2. Press s or t to set your weekday
Wake time (Mon–Fri), then press
NEXT.
3. Press s or t to set the temperature
for this time period, then press NEXT.
4. Set time and temperature for the
next time period (Leave). Repeat
steps 2 and 3 for each weekday time
period.
5. Press NEXT to set weekend time
periods (Sat-Sun), then press DONE
to save & exit.
NOTE: Make sure the thermostat is
set to the system you want to program
(Heat or Cool).
NOTE: You can press CANCEL PERIOD to
eliminate unwanted time periods (except
Wake).
Set Clock/Day/
Schedule
Auto
FanSystem
Cool
Done
Set Day Set Schedule
Mon Tue Wed Thu Fri
Done
CancelPeriod
Leave
Set Schedule
Next
Heat
Setting
AM
62
8
:
00
MCR29462
Run Schedule
Auto
FanSystem
Heat
Heat
Setting
Inside
AM
69
75
6
:
30
Temporary
MCR29463
Press s or t to immediately adjust
the temperature. This will temporarily
override the temperature setting for
the current time period.
The new temperature will be
maintained only until the next
programmed time period begins.
For example, if you want to turn up
the heat early in the morning, it will
automatically be lowered later, when
you leave for the day.
To cancel the temporary setting at
any time, press RUN SCHEDULE.
NOTE: Make sure the thermostat is
set to the system you want to control
(heat, cool or auto).